new account »   log in »
 
 
English polskienglishdeutschрусский
 
 
 
 
 
 
         Products
back
 You are here:  Home Components Ema-elfa Products
» Electromagnetic Brakes
» Powder Brakes and Clutches
» Electrical self-braking motors
» Self-braking motors for quiet operation ( with brakes HPS..AT, 2HPS..BT )
» Electric DC motors ( direct current )
» Electrohydraulic Releases
» Tool boxes
» OZK , PZK discon. and changer-over switches (UL 94 V-0)
» EFM - Control buttons
» ZG , ZW - Sockets and plugs
» Cable Unwinders , Length Meter
» Cold rolled screws and spindles
» Services
»
 

Power supply and current regulator EZP-51

ELECTROMAGNETIC PARTICLE CLUTCH AND BRAKE
CURRENT REGULATOR EZP-51-00


 Technical description

The controller is designed to electromagnetic particle control brakes and clutches in one of the 3 operating modes:
- control using 0-10 V differential voltage input signals
- control using 4-20mA differential current input signals
- control using a 10 kΩ potentiometer
The above mentioned modes permit brake and clutch control across the whole braking moment range of the respective brake or clutch type.

Cooperating equipment, which generate the control signal (e.g. inductive transducers, ultrasonic sensors and proximity sensors, etc.) can be supplied off the terminal strip, using the terminal no. 6, labelled Uin '+' 24VDC 100mA , and terminal 4 '-' labelled GND, while not to exceeding the maximum permissible current draw of 100 mA.
The residual magnetism reduction system utilized, permits operation across a broad parameters range and with high dynamics of braking moment variation. Braking moment is changed by proportionately altering the current flowing in the brake circuit, depending on the control signals. Current stabilization circuits used in the controller ensure constant value of the braking moment

 

DESIGN AND AVAILABLE VERSIONS


The controller consists of three main components: a power supply module, a current source, which supplies brake coil and residual magnetism automatic control system for the electromagnet. The power supply module is housed inside a metal enclosure, whereas the remaining components are placed outside of the enclosure.   


AVAILABLE CONTROLLER VERSIONS:

- EZP51-4           Controller card only
- EZP51-3           Controller card with 10 kΩ potentiometer
- EZP51-2/100-250        Controller card with 100-250V AC/30V DC power supply module
- EZP51-1/100-250        Controller card with 100-250V AC/30V DC power supply module and 10kΩ potentiometer





 

Cantoni MotorBeselCelma InduktaEmitEma-ElfaFanaFormitNarmodFenes


  • Selected division: Components
    Selected company: Ema-Elfa

    Go to:

  • back    top 
    Privacy policy  |  Site map » Copyright © 2020 Cantoni Group. All rights reserved.
    Designed by MOUTON interactive
    follow us: Visitors: 6142523, today: 316